page
21
of
24
3DGence INDUSTRY F340 - maintenance activities | version 04.2019
6.
Position the carriage as shown in the picture (Fig. 38), viewing from the front of the printer:
•
Position the carriage on the X axis as shown in Fig. 39. The marked sheet metal edge should be positioned
in the middle of the fifth mounting hole of the linear guide, counting from the right side (Fig. 39).
•
The carriage on the Y axis shall be positioned as shown in Fig. 40. The marked sheet metal edge should be
positioned in the middle of the black mounting hole of the linear guide, counting from the fan on the rear
side of the printer (Fig. 40).
Fig. 38 Setting up the carriage
Fig. 39 Setting up the X axis carriage
X1 axis
Y axis
Sheet metal edge
set in the middle of
the fifth black mounting hole of the
linear guide
X2 axis
5 4 3 2 1
