3DCPI 3DCPI-03, Руководство для стартапов

Страница: 19 / 38

3DCPI-03
START-UP GUIDE
“Extruder count” Please choose according to your situation,
change the number of nozzles only take effect after you
reboot the software.
“Extruder2”
You can fine-tune the position of Vice-nozzle,
which according to the actual situation stud print calibration,
3DCPI-03 printer defaults to using X-20, Y0 configuration, if
your printer to print double-color model has a misalignment
occurs, appropriate modifications X , Y offset value.
Keep in mind the "main nozzle model color" to help you
identify which part of the model will printed by main nozzles.
Other parameters please use the default value.
2、Basic setting. As shown:
Layer height in millimeters.
This is the most important
setting to determent the
quality of your print. Normal
quality prints are 0.25mm,
max value is 80% of the
nozzle diameter.
Thickness of the walls,
generally set this value to an
integer multiple of the
diameter of the nozzle. Wall
thickness=outer wall + inner
wall.
Enable retraction means that
when nozzle across the
non-printing
area