The most confusing thing about assembling this enclosure will probably be which fastener or
screw to use. Luckily it's easy to figure out once you know the system. While the same screw
to use will be detailed in each section of the manual, you probably won't need to refer to it
once you know the secrets.
The most common screw is the 12mm hex cap head screw. The 12mm screws are long
enough to attach things to the acrylic front, top, sides, and back. Each section will describe
exactly which screw to use, to read carefully, and use the specified screw for the best results.
The actual length of the "long" screws to attach the fan and filter will vary depending on the
depth of the particular shipment of fans we happen to get that month. They will be easy to spot
since they'll be the longest thing in the bags.
Finally, and we can’t stress this enough:
D O N ’T O V E R T I G H T E N T H E S C R E W S
Leave the screws a little loose until the end adjustment phase. During that process, you’ll be
hand-tightening until the screws are snug, but you can easily use so much force on the plastic
pieces or the acrylic crack. Please don’t be
that guy
.
Copyright 2023 3D Upfitters LLC
6
Top Left
Top Right
Bottom Left
Bottom Right
