75
40-D043 Revision C 5-May-17
Settings
Start Z:
Enables the user to choose the Z location of the build file,
where the build will start; if the Start Z value entered is
less than
the
minimum Z extent, the build starts at the minimum; if the Start Z
value entered is
greater than
the maximum Z extent, the build will not
start.
End Z:
Enables the user to choose the Z location of the build file,
where the build will end; if the End Z value entered is
less than
the
minimum Z extent, the build will not start.
AutoDrain:
Checking this box causes the elevator to move the part
to the drain position, which is out of the resin when the build is
complete; when the box is unchecked, the part stays where it is,
submersed in resin, when the build is complete.
Remove Selected Parts:
Enables the user to remove specific parts from a build.
Note: Refer to the
for information on selecting part(s).
