19
3D Systems, Inc
.
NOTE: The print jet tab (A) should be aligned to the front.
34. If the affected extruder is extruder 2, vertically center print jet 2 in the
pinch clamp of the extruder housing and tighten the T10 torx screw (A)
enough that the print jet is securely held. If the printer has only one print
jet, vertically center print jet 1 in the extruder housing and tighten the
T10 torx screw using the T10 x 60 torx driver.
NOTE: For printers with 2 or 3 print jets, the height for print
jets 1 and 3 will be adjusted to the height of print jet 2 after
the printer has been completely reassembled. Tighten the
T10 torx screws enough that the print jets are securely held.
CAUTION: If tightened too tight, the threads in the extruder
might begin to pull making it impossible to secure the print
jet to the extruder. Exercise caution when tightening the torx
screw.
35. Using the 2.5 mm hex driver, reinstall the extruder PCB to the extruder
using the original screws.
CAUTION: Be careful not to damage the print material sensor
(A).
A
A
A