3D AEROWORKS PA-28T IV, Руководство по сборке и инструкция пользователя

Страница: 12 / 28

16
Cut a 100mm length of 3mm square carbon tube and test fit it to the tail section through the
elevator control arm.
Next feed the small “bearing liners” onto the carbon tube and press them into each race. The
bearing liners and races should have a neat fitment with as little play as possible to reduce
slop in the elevator.
17
Glue the “Vertical stabilizer upper rear” section to the “Vertical stabilizer upper front” section.
18
Glue the elevator inner sections to the elevator outer sections. Then glue the elevator halves
together.
NOTE - Only glue the back of the elevators together as this will make adjustment
possible later if required.