3Com SUPERSTACK 3 WEBCACHE 3000, Руководство пользователя

Страница: 82 / 362

82 C
HAPTER
3: U
SING THE
CLI I
NTERFACE
Accessing the
Command Line
Interface
You can access the Command Line Interface using:
■
A terminal or terminal emulator connected to the console port of the
Webcache directly, or through a modem.
■
A terminal or terminal emulator connected to the Webcache over an
IP network using Telnet. You can do this in two ways:
■
Run a telnet session explicitly to the IP address or Domain Name
System (DNS) name of the Webcache.
■
Select System > Control > Telnet in the Web interface. This opens a
telnet session to the Command Line Interface.
You must use a VT52 or VT100/ANSI compatible terminal emulator.
Accessing the
Command Line
Interface Through the
Console Port
To manage the Webcache using the Command Line Interface through the
console port:
1 Connect the terminal or terminal emulator to the console port.
■
If you are connecting directly to the console port, you need a standard
null-modem cable.
■
If you are connecting to the console port using a modem, you need a
standard modem cable. The console port of the Webcache has a male
9-pin D-type connector. You can find pin-out diagrams for both cables
in the
“Cable Specifications and Pin-outs” chapter on page 295 .
To connect the cable:
a Attach the female connector on the cable to the male connector on
the console port of the Webcache.
b Tighten the retaining screws on the cable to prevent it from being
loosened.
c Connect the other end of the cable to your terminal, terminal
emulator, or modem. Make sure that the terminal, terminal emulator,
or modem have the same settings as the console port:
■
8 data bits
■
no parity
■
1 stop bit
dua1611-5aaa04.book Page 82 Friday, November 29, 2002 8:56 PM