Using the quickstart Command
5
Figure 1
Single-Switch Deployment
To run the
quickstart
command:
1
Attach a PC to the WX switch’s serial console port.
(Use these modem settings: 9600 bps, 8 bits, 1 stop,
no parity, hardware flow control disabled.)
2
Press Enter three times, to display a username prompt
(Username:), a password prompt (Password:), and
then a command prompt such as the following:
WX1200>
3
Access the enabled level (the configuration level) of
the CLI:
WX1200>
enable
4
Press Enter at the Enter password prompt.
5
Type
quickstart
. The script asks you a series of ques-
tions. You can type
?
for more help. To quit, press
Ctrl
+
C
.
One of the questions the script asks is the country
code. For a list of valid country codes, see the
Wire-
less LAN Switch and Controller Installation and
Basic Configuration Guide
. The country codes are
listed in the “Configuring a WX Switch for Basic Ser-
vice” chapter, in the “Specifying the Country of Oper-
ation” section.
10.10.10.4
Port
3
WX1200-C
orp
Port
2
Backbone
alice
Console
Internet
Corporate resources
user1
bob
user2
MAP
MAP
