3Com NETBuilder II, Инструкция по установке, Страница: 31 / 82

Installing the 8-Slot Chassis 2-3
Installing in a Rack
Your chassis comes with a rack-mount kit, which consists of two brackets, 10
pan-head screws, and four locking nuts. This kit allows you to mount the
chassis in a 19-inch, 2- or 4-pole rack. Make sure the kit contains all of these
parts. If a part is missing, contact your network supplier.
You will need a Phillips screwdriver to mount the system in your rack. You will
probably need two people to complete the procedure: one person to hold the
system and the other person to attach it to the rack.
CAUTION: Using fewer than three screws on each side of the NETBuilder II
chassis to secure the rack-mount brackets may result in bracket failure and
damage that will invalidate the warranty.
Follow the steps in Figure 2-2 to install your 8-Slot chassis in a rack.
Figure 2-2 Installing an 8-Slot Chassis in a Rack
NETBuilder II
NETBuilder II
Remove the six pan-head
screws from sides of chassis.
Install the brackets using the pan-head
screws supplied with your rack-mount kit.
®
NETBuilder II
c
b a
Place the locking nuts over the holes in the rack where you plan
to install the unit. Insert the screws and tighten them
with the Phillips screwdriver.
Locking nut
(see detail)