Selecting The Service Provider
Select the service provider from a list, as the graphic below indicates
.
Click
Next
to continue.
NOTE:
If you chose
Bell South Fast Access and Internet Service
, you will be prompted to choose
between “PPP over ATM” and “Ethernet (Bridge) PPP over Ethernet.” Choose the one recommended by
your service provider, then click
OK
.
If you chose your service provider from the list above, skip ahead to the
Selecting the
Destination for ADSL Files/Control Center
section of this document. When you get to the “Start
Copying Files” screen, verify the setting you received from your service provider with the settings
displayed on this screen. Although you should not have to change any settings, double check
them against the information supplied by your service provider and make changes, if appropriate.
If you are in one of the categories listed below, highlight
Custom
in the above screen and
continue with the installation using the service provider settings.
??
Choosing Other Service Provider
??
Service Provider is not Listed
??
Service Provider offers Multiple Types of Connection Methods
Select the connection method specified by your service provider. You may need to enter the
correct Virtual Path Identifier (VPI) and Virtual Channel Identifier (VCI) values. The service
provider will supply these.
The following are the connection methods available:
??
PPP over ATM (VC Multiplexing) Use this for upgrading where current setup is PPPoA.
??
PPP over ATM (LLC).
??
Ethernet (Bridge/PPP over Ethernet)
??
Ethernet (Routed)
