3Com CS/2500, Руководство по установке, Страница: 44 / 116

3-6 C
HAPTER
3: S
TARTUP
12 Insert the master (source) diskette (the diskette you want to copy from)
and press the Return key.
The server copies files from the master diskette. The following message
appears:
reading...OK
insert copy and hit return to continue
13 Remove the master diskette.
14 Insert the formatted copy (destination) diskette (the diskette you are
copying to) into the diskette drive and press the Return key.
A message similar to the following appears during and after copying:
writing...verifying...OK
Copy another disk? (y/n):
If you want to copy another diskette, type
y
. If you do not want to copy
another diskette, type
n
.
15 When the copy procedure is completed, remove the newly created
diskette and label it with the software version.
Store the original diskette in a safe place, and use a newly created
diskette as your working diskette. Make sure the working diskette is not
write-protected.
Once you have copied your diskettes, you are ready to start the server.
Refer to “Booting the Communications Server” on page 3-7 for the
procedure.
Formatting Diskettes without the Copy Command
You can also format diskettes without the copy command by using the
following procedure:
1 Enter monitor mode by following steps 1 through 7 in the previous copy
procedure.
2 To format a diskette, enter the format command:
fo
The following message appears:
Insert diskette to be formatted
CS2500BookFile : Startup Page 6 Thursday, December 11, 1997 10:44 AM