3Com CoreBuilder 3500, Руководство по началу работы

Страница: 27 / 96

2
I
NSTALLING THE
S
YSTEM
This chapter describes how to install your
CoreBuilder
® 3500 system on a table top or in a
distribution rack.
■
To install the system on a table top, read these
instructions:
■
Before You Begin
■
Installing the System on a Table Top
■
To install the system in a distribution rack, read
these sections:
■
Before You Begin
■
Installing the System in a Distribution Rack
Before You Begin
Before you begin the installation procedures, be sure
that you:
■
Move the system close to where you plan to
install it.
■
Have a No. 2 Phillips screwdriver available.
■
Have the system mounting kit available. See
Table 5.
Installing the System on a Table Top
To install the system on a table top:
1
Place the system on its side on the table.
2
Remove the protective covering from each rubber
foot to expose the adhesive surface.
3
Place one rubber foot in each of the marked areas at
the corners of the bottom of the system.
4 Turn the system onto its feet.
5
Ensure that nothing blocks the air intake and fan
exhaust vents.
You are now ready to install the media modules into
the system. For installation instructions, see Chapter 3
or the guides that are shipped with the modules.
Table 5 System Mounting Kit
Item Qty To use in
Rubber feet (self-
adhesive) 4 Table top installation
Mounting bracket 2 Installing the system in the
distribution rack
8-32 x 1/2 Phillips flat-
head screws 8 Installing distribution-rack
mounting brackets
10-32 x 1/2 Phillips
pan-head screws 4 Installing the system in the
distribution rack