3Com 3C17203 - SuperStack 3 Switch 4400, Руководство по началу работы

Страница: 33 / 76

Manual Setup 33
Manual Setup
You can set up a Switch manually in the following ways:
■
Connecting to a front panel port — Connect a workstation using an
Ethernet cable to a front panel port of the Switch. You can then
manually enter IP information using the web interface.
■
Connecting to the console port — Connect a workstation using a
console cable to the console port of the Switch. You can then
manually enter IP information using the command line interface (CLI).
Connecting to a Front
Panel Port
To set up your Switch manually you can make a connection to a front
panel port. You must do this whilst the Switch is offline, that is, before
you connect the Switch to a network.
Pre-requisites
■
A workstation running Windows 95/98/2000 or Windows NT.
■
A Network Interface Card (NIC).
■
A Category 5 twisted pair Ethernet cable with RJ-45 connectors.
■
A suitable Web browser — refer to “Choosing a Browser” on page 44 .
■
You need to have the following so that you can manually set up the
Switch with IP information:
■
IP address
■
subnet mask
■
default gateway
Connecting the Workstation to the Switch
1 Connect the workstation to a front panel port using an Ethernet cable as
shown in
Figure 7 .
Figure 7 Connecting a workstation to the Switch via a front panel port
DUA1720-3AAA03_online.book Page 33 Monday, March 25, 2002 10:48 AM