3Com 3C16710 - OfficeConnect 8/TPM Hub, Руководство пользователя

Страница: 39 / 130

Configuring Multiple Hubs 4-3
If you are going to manage over a serial link from
your management station, Quick Config Manager
uses COM1 as the default serial port. You can
change this by editing the following line under the
[slip] subsection of the QUICKMGR.INI file:
SerialAttrib=COM1:9600,n,8,1
Editing it to
SerialAttrib=COM2:9600,n,8,1
changes the default serial port to COM2.
Configuring Multiple Hubs
There is a special feature which allows you to
connect your management station to a new
OfficeConnect® Hub 8/TP M without needing to
close and reopen Quick Config Manager. This is
particularly useful if you have many OfficeConnect
hubs that need configuring or monitoring.
This feature only works if all the hubs you are going
to connect to have the same baud rate (or are set to
Auto Config) as the management station.
To do this:
1
Make your serial connection to the new hub.
2
From the File menu, select Reset View .
Quick Config Manager closes any windows that are
open in preparation for the new management
session.
Quick Config Manager Window Map
Figure 4-1 (over the page) shows how all of the Quick
Config Manager windows are accessed. This diagram
also appears on the Quick Reference Guide. The
number at the top right-hand side of each window
refers to the page that describes the window.
16710.bk : MANAGING.FRM Page 3 Tuesday, October 7, 1997 11:38 AM