2VV STANDESSE, Руководство по установке

Страница: 14 / 31

5.4 ELECTRO INSTALLATION
•
The air curtain’s electrical connection must be based on a professional design by a qualifi ed electrical
systems engineer.
•
Installation must be carried out by a professionally trained electrical worker. All applicable national
regulations and directives must be observed.
•
The electrical schematics on the product take priority over those presented in this manual!
•
Prior to installation, check to see if the terminal markings correspond to the markings on the elect-
rical connections diagram. When in doubt, contact your supplier and do not connect the air curtain
under any circumstances.
•
Never reach inside the air curtain unless the main electrical supply has been turned off !
•
If the product is connected to any control system other than the original one, the regulation and me-
asurement components must be connected by the company that supplied the system.
•
The electrical contractor defines the minimum size of the feed cable according to the standards appli-
cable at the place of installation, the location for installing the cable, the surrounding conditions, and
the curtain‘s technical parameters.
•
Special attention should be paid to the capacity of the distribution network of the air curtain
with electric heater in terms of the supply of the appropriate phase current values for limiting
the voltage fluctuations and flickering in the network.
Minimal cable dimensions:
Type Cable dimention
VCS4-x-xxx-S… 3Cx1,5
VCS4-x-xxx-V… 3Cx1,5
VCS4-x-xxx-W… 3Cx1,5
VCS4-x-100-E… 5Cx2,5
VCS4-x-150-E… 5Cx4
VCS4-x-200-E… 5Cx6
VCS4-x-250-E… 5Cx10
Fuse motors:
VCS4-x-xxx…
x
B C
xxx
100 3,15A 5A
150 4A 6,3A
200 6,3A 8A
250 8A 12A
6. INSTALLATION