16
17
2VV.
Creating innovative solutions for you and your business since 1995.
MENU - HW SETTING
Motor 1
In the quantity of the “number
of motors” menu, select the
value “1”
Motor 10
..........
..........
GND
GND
Ad 1)
Ad 2)
Ad 3)
Ad 4)
Change mode (NO/NC)
External control contact
(NO/NC)
Error contact (NO/NC)
Ad 1)
- Activation/settings of outer temperature sensor. Available selections:
None
- sensor not connected/inactive
EXT-1 (45,46)
- sensor connected (must be on connectors 45 and
46)
BMS
- active temperature sensor and used from master system
Ad 2)
- Setting the behavior of external contact input. Available selections:
None
- inactive
External control
- External activation/deactivation of device
Ad 3)
- Not used.
Ad 4)
- Number of connected EC motors on regulator: 0-10ks
Don't forget to connect the speed outputs of the motors to the
appropriate connectors
on the panel of the regulator, per the following schematic:
If the situation should occur that it is not required to check the speed output of
the motors, this function can be blocked:
And join the 1+2 connectors per the schematic below.
In this MENU you can set the detailed behavior of the individu-
al regulator inputs and outputs
7. OPERATION
Servicing menu
MENU - MODE
Use code 1616 to access the servicing MENU
1616
Select the MENU
after scrolling to
the middle of the
page and click-
ing to enter
If no engine with tacho or termo contact
is connected.
Connectors 1 and 2 must be connected.
Enter menu
Enter selected
menu
Delete/go back
Only automated mode can be set for
this regulator.
Activation/deactivation of automatic
motor rotation control by temperature
