2N Lift1 Compact, Руководство пользователя

Страница: 56 / 83

56
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Evaluation of Loud Automatic Dialling without Confirmation
Situation Response
Silence/busy tone after
line pick-up
This situation does not affect the 2N Lift1
®
operation. 2N
®
Lift1 makes dialling at any line state and only then
evaluates the situation.
Busy tone
2N Lift1
®
hangs up in approx. 2 seconds and dials the
next number.
Call or silence
2N Lift1
®
waits for a preset time (login timeout), then
hangs up and dials the next number.
Continuous tone (on
PBX line)
2N Lift1
®
hangs up in approx. 2 seconds and dials the
next number.
Ringing tone, which
stops before 10 rings
(configurable) The call is considered successful, takes the maximum
preset time (Maximum call time). The message is played
. once
Ringing tone, which
reaches 10 rings
(configurable)
2N Lift1
®
hangs up and dials the next number.
through ,
These digits are interpreted as a beginning of the switch
control password.
2N Lift1
®
hangs up and dials the next number.
Call End (Outgoing/Incoming)
The call end (line hang-up) occurs whenever any of the below listed situations
happens:
The busy or continuous tone is detected (PBX call end).
The maximum call time expires –
plays "Attention, the call is ending" 2N Lift1
®
10 seconds before expiration for you to extend the call if necessary.
The or character is received.
The time limit expires during programming.
The count of ringback tone periods exceeds the value set in parameter 954; the
dialling attempt is terminated and calling continues according to the automatic
dialling parameters.
Warning
Make sure before using this mode that no VoiceMail box, fax machine or
any other device that could answer the call before the preset rings is
installed on any of the numbers to be called to avoid automatic dialling
termination.
Note
The communicator is able to detect the continuous, busy and ringback
tones even if the tone had two frequency components as in Great Britain,
USA
and Canada. (BTT)