2N Lift1 Compact, Руководство пользователя

Страница: 38 / 83

38
2N TELEKOMUNIKACE a.s., www.2n.cz
®
1.
2.
3.
4.
5.
6.
7.
Procedure
Switch on the programming mode: service password .
Enter the message recording command: 972 service password .
A continuous tone (up to 15 s) signals that the respective memory section is
being deleted. Wait until the tone stops and you hear the confirmation tone
.
Now
is recording the message of the maximum length of 30 s. 2N Lift1
®
Press any digit (DTMF) on your phone to stop recording if your message is
shorter than 30 s.
The recorded message is played back for check immediately.
Now go on programming.
Acoustic Settings
In the HandsFree mode, the sound path is muted when there is 2N Lift1
®
"silence" on both sides. When a certain sound level is exceeded, the speaker or
microphone switches on depending on which party is speaking (or speaking more
loudly).
The optimum acoustic parameters are set by default and should be modified in
exceptional cases only.
Use parameters 931 through 938 to modify these values.
Note
The maximum message length is 30 seconds, Therefore, we recommend
you to prepare the text and test the message time in advance. Remember
that the lift must be identified uniquely and that some messages are
intended also for foreigners, in hotels, for example. Speak distinctly and
loudly and watch the time while recording long messages.
The message quality depends on the speaker (professional speakers are
recommended for official announcements), phone (do not use HandsFree
or obsolete carbon microphone telephone sets), ambient noise and
connection quality (the best solution is to record a message via a PBX in
advance).
Message check: the message is played back
immediately after for check
recording.