2N IP Force 9151101CHKW, Руководство по установке

Страница: 91 / 118

Installation manual 2N® IP Force
91 / 118
•
•
•
•
•
•
added to an existing installation. Thanks to its compact dimensions, the
device can be installed into a standard mounting box.
Connection:
Connect the 2N
®
Security Relay to the intercom as follows:
To the intercom active output (OUT1 or OUT2 if a reader module or additional switch is connected)
Connect the electric lock to the 2N
®
Security Relay output as follows:
To the switched output.
To the passive output in series with the external power supply.
The device also supports a Departure button connected between the ‘PB’
and ‘- HeliosIP/IP intercom’ terminals. Press the Departure button to activate
the output for 5 seconds.
Status signalling:
Green LED Red LED Status
blinking off Operational mode
on off Activated output
blinking blinking Programming mode – waiting for
initialisation
on blinking Error – wrong code received
Configuration:
Connect the 2N
®
Security Relay to the properly set intercom switch output; refer to the Configuration
Manual. Make sure that one LED at least on the 2N
®
Security Relay is on or blinking.
Press and hold the 2N
®
Security Relay Reset button for 5 seconds to put the device in the programming
mode (both the red and green LEDs are blinking).
Activate the intercom switch using the keypad, telephone, etc. The first code sent from the intercom will be
stored in the memory and considered valid. After code initialisation, the
2N
®
Security Relay will pass into
the operational mode (the green LED is blinking).