2N BRI Lite, Руководство пользователя, Страница: 20 / 152

2N TELEKOMUNIKACE a.s., www.2n.cz 20/152
2N BRI Enterprise / BRI Lite
®
is intended for indoor use. It may not be exposed
to rain, flowing water, condensing moisture, fog, and so on.
2N BRI Enterprise / BRI Lite
®
may never be exposed to direct sunshine or
placed close to heat sources (radiators).
A sufficient clearance must be kept over and under 2N BRI Enterprise / BRI Lite
®
for cabling and air flow to carry off the heat.
A sufficient GSM/UMTS signal intensity has to be provided for 2N BRI
®
. Enterprise / BRI Lite
An adequate capacity of the GSM/UMTS network has to be ensured (no BTS
overload). Remember that multiple GSM gateways used in one location may
overload the base transceiver station (BTS) you are currently logged in to. This
may lead to a permanent or occasional rejection of GSM/UMTS calls!
No strong electromagnetic radiation is allowed on the 2N BRI Enterprise / BRI
®
installation site. Lite
No strong electromagnetic reflections are allowed on the 2N BRI Enterprise /
®
antenna installation site. BRI Lite
An inappropriate location of or its antenna close to 2N BRI Enterprise / BRI Lite
®
television, broadcasting and/or other rf-sensitive sets may impair the function of
these sets.
Being a source of radio frequency emissions, the 2N BRI Enterprise / BRI Lite
®
antenna should not occur in the close vicinity of the human body. The health
hazard is higher than with mobile phones as, generally, gateways shared by
multiple users show a very high traffic.
It is recommended that the power supply adapter should be connected to a
network with a UPS back-up and due overvoltage protection.
SIM Card Inserting/Removing
Insert the SIM card in the bottom as shown in the figure. 2N BRI Enterprise / BRI Lite
®
As the SIM slots are of the Push/Pull type, just slide the card in and push it into
position. Push the SIM gently to slide it out of the slot.