2N Telekomunikace EasyGate IP, Краткое руководство

Страница: 3 / 24

1. SIM Card Installation
Insert a SIM card without PIN request into the SIM 1 slot on the device bottom side. Remember to set PIN
deactivation and such provider services as call forwarding, call barring, preferred networks, SMS center, etc. in your
mobile phone, for example, before inserting the SIM card in 2N® EasyGate IP.
2. Antenna Connection
Screw the enclosed antenna into the SMA antenna connector. Tighten the antenna connector gently with your
hand, never use a wrench!
3. Device Connection to Power
Connect the included power supply terminal block into the dedicated Power connector and connect the power
supply to the electrical mains.
We recommend that the Panasonic HHR-210AAB batteries included in the factory product delivery are used for
supply backup.
Use 2N® Elevator Center, a licensed cloud service, for 2N® EasyGate IP remote management. Contact your distributor
for the service access data. Refer to 2n.com for more details on 2N® Elevator Center.
To configure 2N® EasyGate IP without the 2N® Elevator Center cloud service, connect the device to a PC via a USB
cable using the 2N® EasyGate IP – Web configuration utility available for free download at 2n.com.
The 2N® EasyGate IP local connection tool also includes a manual, which describes the tool installation and guides
the user as far as the web interface login page. For the first login, enter Admin as the username and 2n as the
password. You will be prompted to change the default password upon the web interface login.
Refer to the full 2N® EasyGate IP User Manual at wiki.2n.com for configuration details.
3
Mechanical Installation
2N® EasyGate IP is designed for indoor mounting on a vertical surface using a DIN rail bracket (35 mm) or a wall
bracket using screws fitted to the bracket mounting holes. The installed device is intended for continuous operation
at a minimum distance of 20 cm from the user.
Wall Mounting
Use the bracket and two dowels with screws included in the package to install 2N® EasyGate IP on a wall. Drill holes
in a selected place and selected height of the wall and insert the dowels. Pass the screws through the bracket holes
and screw them into the dowels in the wall. Now all you have to do is slide 2N® EasyGate IP from the top into the
DIN rail bracket profile and fit its position with a screw.
DIN Rail Mounting
No other tool is needed for DIN rail installation. Put the upper inner side of the bracket profile on the DIN rail and
push its bottom side to make the bracket click and fit to the DIN rail. Now all you have to do is slide
2N® EasyGate IP from the top into the DIN rail bracket profile (A) and fit its position with a screw (B).
!!! Only vertical mounting with the connectors heading down guarantees that the device is water-
proof. If installed otherwise, the device may be infiltrated with water and damaged irreversibly !!!
The device may be operated in a temperature range of 0 °C – 45 °C if equipped with the provided
batteries, or at temperatures outside this range without these batteries. Make sure that batteries
with increased thermal resistance are used to preserve the backup function. You can connect an
external battery with increased thermal resistance or place the external battery to a place with a
convenient temperature.
Putting in Operation
EN
23