2N Telekomunikace 2N Access Unit 916009, Руководство по установке

Страница: 51 / 70

51
2N TELEKOMUNIKACE a.s., www.2n.cz
®
2.4 Připojení rozšiřujících modulů
2N
®
Access Unit allows to connect following extending modules:
Infopanel
Klávesnice
125kHz RFID card reader
13.56MHz RFID card reader
I/O modul
Electronic buttons
Wiegand modul
Security relay
Module Bus Interconnection
All the modules that can be connected to are interconnected via a 2N
®
Access Unit
bus. The bus starts on the basic unit and goes over all the modules. The order of
modules on the bus is irrelevant. And it also irrelevant which bus connector on the
module is used as the input and which is used as the output.
The modules include a 220 mm long bus interconnecting cable; Wie Part No. 9155037
gand modules and I/O modules include an 80 mm long bus cable. Part No. 9155034
You can order a separate 1 m long bus cable ( , , Part Nos. 9155050 9155054
) of the length of 1 m, 3 m or 5 m for remote module installation. Typically, it 9155055
helps install an RFID card reader on the opposite side of the wall on which the 2N
®
is installed. This long cable can only be used once on the bus. Access Unit
The modules can be combined in each base as follows:
Module
Externally mounted
(visible module) Internally mounted
(invisible module)
Infopanel X
Klávesnice X
125kHz RFID card reader X
13.56MHz RFID card reader X
I/O modul X
Wiegand modul X
Module Power Supply
All the modules connected to , except for the Tamper Switch, are 2N
®
Access Unit
powered from the bus. The available bus power output depends on the power supply
type. The basic unit can use a 2A power supply to increase the bus power available to
the modules connected.
Power supply Specification Available power output
External supply 12 V ±15% / 2 A (3 A) 24 W (36 W)
PoE 802.3af (Class 0 – 12.95 W) 12 W
Combined External PoE 30 W (42 W)
The count of modules on the bus is limited by the available power supply output. The
maximum count of the modules on the bus is 30.