Programmable Plug in Thermostat TC-300
Parameter Settings
Under off status, press “M” button and “+”button at the same time. You be able to enter the parameter settings. Each
press of “M” button can into next item setting.
No.
Item
Range
01
Temp. Calibration
-9
～
+9 'C
02
High Temp. Limit
0
～
65 'C
03
Low Temp. Limit
0
～
65 'C
04
Frost Protection
5
～
10 'C
05
Dead Band
0.5
～
2 'C
06
Heat pump protection
0
：
OFF 1: ON
07
Eeprom( Memory)
0:OFF 1: ON
08
Software Version
100C
Mode Temperature Pre-set.
The Mode temperature can be set as the below following steps:
-
Press and hold the “M” button for around 3 seconds. The COMFORT mode (pic. A) display.
-
Change the mode temperature by the “+” or “-” buttons.
-
Press “M” button , the Energy-saving mode display (pic. B).
-
Change the mode temperature by the “+” or “-” buttons.
-
Press “M” button , the holiday mode display (pic. C).
-
Change the mode temperature by the “+” or “-” buttons.
The comfort function is displayed as a
symbol (e.g. 25.5°C).
The energy-saving function is displayed as a symbol (e.g. 20.5°C).
The holiday function is displayed as a
symbol (e.g. 10°C).
To leave this menu, just wait 10 seconds or just push on the on/off button. The setup will be memorized
by the EEPROM (when this feature is enabled).
Pic.A
Pic.B
Pic.C
