11Wave Technology WaveBuddy EWC-351WA1, Руководство пользователя

Страница: 19 / 33

11Wave Technology Inc.
16
the type of network adapter card that you are going to use.
4) When prompted to select a driver, locate the driver provided with your Drivers, and Software
Tools CD.
5) Next Windows will start copying the files. In case there is a version conflict between one or
more of the files being copied and the files in your system, you should normally keep the
latest version.
6) Finally, when the installation has been completed, you will need to restart your computer.
Note : If the card is not working properly, after a restart procedure, you should make sure that
your system has free resources ever it may shows them as being available.
4.4 Install PC Card
Since Windows NT 4.0 do not support “Plug & Play”, you must enable the detection of PC cards
by the operating system by following the following procedure:
1. Click Start->Settings->Control Panel.
2. Double-click the “Devices” icon
3. Select “PCMCIA” from the list and click the “Startup” button.
4. Set the Startup type to “Boot” and click “OK”.
5. Click “Close” on the “Devices” window.
In order to let the operating system know about your new card, you must enable the Network
support:
1. Click Start->Settings->Control Panel.
2. Double-click the “Network” icon.
3. In the “Network Settings” window you will be prompted to install Windows NT Networking
in case no network has been installed yet. Click “Yes” and follow the instruction on the
screen. If networking had been already installed, you will see a dialog with several tabs. In
the “Adapters” tab click the “Add” button. Windows NT Networking Setup will determine
the type of network adapter card that you are going to use.
4. When prompted to select a driver, locate the driver provided with your Drivers, and Software
Tools CD.
5. During the installation, a dialog box appears asking for the I/O Base and IRQ resource
information. In order to find out which values to use, go to Start -> Programs ->
Administrative Tools -> Windows NT Diagnostics -> select the “Resources” tab -> press the
“IRQ” button. Select one free IRQ from the list. Next, press the button “I/O Port” and choose
an 0x20 free I/O space. Add these values into the dialog box. If at any point after the
installation you want to change these values, go to the Control Panel -> Network, select the
Adapters tab, press the Properties button, and fill in the new values.
6. Next Windows will start copying the files. In case there is a version conflict between one or
more of the files being copied and the files in your system, you should normally keep the
latest version.