Calibre 416
Mechanical Movement Operation Manual
A Mechanical watch is a device for keeping time, which uses the energy from a wound spring,
and keeps time through the highly regulated release of that energy through a set of gears (the
wheel train) and an escapement. It differs from typical quartz watch in that it uses purely
mechanical components to keep time. Mechanical watches typically can run for about 40
hours on one full winding of the mainspring.
Important
Over wind of the spring may cause damage to the mainspring. Only wind the spring as
far as it will go but not beyond.
Time Stand Accuracy
1)
21,600 beats per hours
2)
Accuracy between -30 to +30 seconds per day worn under normal conditions.
Butterfly Strap Adjusting Instruction
Firstly, open the butterfly buckle and then pull out the pin. Adjust the strap to the required
length, and then push back the pin into the correct hole. Finally, close the butterfly buckle until
it clicks into place.
Page 1
Water Resistance Table
Level of
Water
Resistance
Suitable for
Everyday
use
Can
withstand
accidental
splashing
Suitable for
Swimming
Suitable for
Pool Size
Suitable
for
snorkelling
or water
sports
Suitable for
high board
diving or sub-
aqua diving
None
Yes
No
No
No
No
No
3 ATM
(30m/
100ft
Yes
Yes
No
No
No
No
5 ATM
(50m/
150ft)
Yes
Yes
Yes
Yes
No
No
10 ATM
(100m/
300 ft)
Yes
Yes
Yes
Yes
Yes
No
Water resistance is not permanent. In the course of time, the gaskets of the case and
crown may become worn and reduce the water resistance of your watch. We recommend
the periodic checking
Normal Crown
– always make sure it is pushed fully into case
Screw down Crown
– tighten screw down crown completely to screw lock position.
To maintain water –resistance crystal, crown and case must remain intact
Exposure to Salt Water
If your watch is designed for sports or working in the water and it becomes exposed to salt
water or significant amounts of perspiration, it should be rinsed in fresh water and dried
thoroughly with a soft dry cloth.
Important
Buttons must not be operated while in contact with water
Page 2
Functions
-
Hours
-
Minutes
-
Seconds
-
Dual Time
-
Day / Night (AM / PM) Dial
-
Water Resistance – Check the back of the watch and refer to the Table.
Instructions For Setting Dual Time and Home Time
1)
Pull the crown out to First Position and turn the crown anti-clockwise to set the
dual time on left dial. For example, Local Time is 12 o’clock duel time can be set
for different country’s Local Time i.e. Paris 1o’clock. Refer to the World Time
Zone table on Page 4.
2)
Once the correct duel time is set, turn the crown clockwise to set the correct
Home Time.
3)
Finally push the crown back to Normal Position.
4)
Day / Night dial will show Sun for AM and Moon for PM time.
Page 3
World Time Zone Table
OFF SET
HOURS
TIME ZONE
STANDARD HOURS
OFF SET
HOURS
TIME ZONE
STANDARD HOURS
0
London
0
London
+1
Paris/ Berlin/ Madrid
-1
Cape Verde
+2
Istanbul
-2
Mid-Atlantic
+3
Moscow
-3
Greenland
+4
Abu Dhabi
-4
Santiago
+5
Islamabad
-5
USA (Eastern)
+6
Dhaka
-6
USA (Central)
+7
Bangkok
-7
USA (Mountain)
+8
Beijing / HK
-8
USA (Pacific)
+9
Tokyo Seoul
-9
Alaska
+10
Sydney
-10
Hawaii
+11
Guam
-11
Samoa
+12
New Zealand
-12
Kwajalein
Page 4
Calibre 416
IN2705WH
Page 5
