SETUP & TAKE DOWN INSTRUCTIONS
SUNSET 170 10’x10’ INSTANT CANOPY
SECURING THE CANOPY TOP TO THE FRAME
THANK YOU FOR PURCHASING A YOLI INSTANT CANOPY!
Please carefully review the following instructions and familiarize yourself with parts included
and how to operate your YOLI canopy. Reference parts list for names of each part noted in instructions.
Parts Included:
Canopy frame (1), Canopy top with dual awnings (1), Canopy vent tops (2),
Steel shock cord poles (2), Steel shock cord bag (1), Wheeled carry bag (1), Stakes (4)
1
2
3
Take temporary protective sleeve as pictured in
(Fig. 1A)
off and discard.
Place the canopy in the desired location
(Fig. 2A)
.
With partner, stand on opposite side of the frame. While holding the legs lift slightly off the ground
taking a few steps backwards to extend frame at full arm’s length as shown
(Fig. 3A).
Open the canopy frame to about 75% and pull the awning arms out until locks into 1st position as pictured in
(F
ig. 4A
).
Drape the canopy top over the frame. Opening in the center of top accommodates canopy vent tops. Make sure long portions
of canopy top are on the two sides where the awning arms are located as pictured in
(Fig.4B).
4
Secure top by attaching corner of the canopy top to black fastening strip
(Fig. 5A)
. Repeat for all corners.
5
Attach the canopy top awning to awning arms by using the elastic loop as shown in
(Fig. 6A).
Repeat for opposite side. Unlock awning arm from 1st position by puling on the ring pull pin. Your top is now secured to the frame.
6
2A
Fig.
3A
Fig.
4A
Fig.
4B
Fig.
1A
Fig.
5A
Fig.
6A
Fig.
