Module LEDs
The module has several LEDs included to indicate status:
SDI Present LED (electrical or fiber input)
= Valid SDI Signal connected
= (out) non valid SDI signal or signal missing
Audio Status LED
When in “deembeder” mode the LED displays status of the embedded audio in the SDI
signal. When in “embedder” mode the LED displays the status of the external audio inputs.
= Both stereo pairs have at least one audio channel present
= One stereo pair is missing both channels, the other has at least
one channel present
= (out) no audio present
Power / Prog. Setting LED
= Power OK and no internal programmed settings are present
= Power OK and some programmed settings are active*
= One or more module switch settings have been overwritten
with the yelloGUI application. (Operation of any local switch will
clear internal settings and restore all local switch settings)
= (out) Power not present
* Some additional internal settings have been made using the yelloGUI and the
LED indicates this by turning yellow. The module can be reset to factory defaults
by using the reset switch (recessed under a hole on the side of the module).
USB Port / Firmware Updates / yelloGUI
The USB interface on the module is used for firmware updates and for
control of the module using the yelloGUI software application.
To update a yellobrik, power it and connect it to the PC or Mac running
the yelloGUI software with the provided USB cable. The yelloGUI
software will indicate if a new firmware is available for the connected
module and will guide you through the update process.
Firmware updates are always free of charge.
For more information and to download the yelloGUI application please
go to:
http://yellogui.lynx-technik.com
yellobrik
Quick
Reference
®
PDM 1383
3G Analog Audio Embedder / Deembedder
Warning
Class 1 Laser Product
Power Lead Strain Relief
The module has a small hole in the case located above the power
connection. To prevent the power lead being accidentally pulled out,
use the supplied tie-wrap and secure the lead as shown below.
LYNX
Technik
AG
SDI Input
SDI Output
Fiber I/O (option)
12V Power Input
SDI Present
Audio Level
Select
Audio Group
Select
Power and
Prog. Settings LED
Module Settings
Module Reset
(through hole)
Analog Audio I/O
USB
(
for prog. settings and
firmware updates)
Audio Status LED
Fiber I/O Options
The PDM 1383 can accommodate several fiber
options which are detailed below. These are
SFP sub modules and simply plug into the side
of the module. These can be added at any time.
We can also supply WDM versions as well as
CWDM versions in 18 different wavelengths if
required. Please contact LYNX Technik if you
would like more information on fiber options.
SDI Fiber Transmitter Options
Description
Power
OH-TX-1-LC / ST / SC
SFP Fiber TX - Singlemode - LC, ST or SC conn. - 10km
-5dBm (1310nm)
SDI Fiber Receiver Options
Description
Sensitivity
OH-RX-1-LC / ST / SC
SFP Fiber RX - Singlemode - LC, ST or SC connector
-18dBm
SDI Fiber Transceiver Options
Description
Power
Sense
SFP Fiber RX/TX - Singlemode, LC Connector - 10km
-5dBm
-16dBm
OH-TR-0-850
SFP Fiber RX/TX - Multimode, LC Connector - 300m
-5dBm
-15dBm
Model
Model
Model
OH-TR-1
