background image

Mug Mixer, Type MG600H 

Commodity code: 231206 

Instruction Manual 

First Edition 

 
 

 Thank you for purchasing Yamato’s Mug Mixer. 

 In order to ensure correct operation of the mixer, be sure to read this manual and the guarantee card 

carefully. 

  After reading, keep the manual together with the guarantee card in custody so that you can refer to it any 

time. 

 
 

1.  Cautions for Handling 

(1) This product is not of an explosion-proof structure and must not be used in the inflammable 

atmosphere. 

(2) Be sure to establish the earth of the product. 

(3) The stirring table of the product is a hot plate.    Pay due attention not to suffer burn. 

(4) The product is based on the safety design to protect the internal mechanism, so that the heater circuit 

is not activated unless stirring is made.    To heat the hot plate, be sure to turn the STIR knob to ON, 
then turn the HEAT knob to ON. 

(5) The hot plate has the ceramic coating that may be damaged when rubbed with a hard object. 

(6) When raising the rotation speed, raise it gradually.  With sudden increase of the rotation speed, the 

stirrer can not follow the speed, resulting in failure to turn. 

(7) Note that, when the temperature rises, the sample may have the viscosity lowered and splash. 

 

2. Operation Method 

(1) Set all of six frequency select switches on the main body backside to the frequency of power supply to 

be applied. 

(2) Install the product in a stable place, confirm that the POWER switch is OFF, the HEAT knob is OFF, 

and the STIR knob is OFF, and connect the power cord to AC 100V.    Be sure to connect the earth 
wire. 

(3) Place the stirrer in the container and place the container in the middle of the stirrer table to be used. 

(4)  Turn ON the POWER switch and turn the STIR knob of the same number as the stirrer table to be used 

to the ON position.  Stirring begins.  Turning the know further clockwise causes increase in the 
stirring speed. 

(5) Turn the HEAT knob of the same number as the stirrer table to be used to the ON position.  The 

heater is energized and the red pilot lamp goes ON.    Turning the knob further clockwise causes the 
set temperature of the hot plate to rise further.  When adjusting the temperature, turn the knob 
properly to the desired position while measuring the sample with the thermometer.  Since the set 
temperature may deviate depending on the shape of sample container and the sample liquid amount, 
reset the knob each time while measuring the sample with the thermometer. 

(6) Stirring and hot plate heating can be made for maximum six samples simultaneously.  Set the 

temperature for each sample individually. 

(7) The motor rotation speed may decelerate depending on the temperature of hot plate.  Adjust the 

rotation speed to the desired value while checking the stirring condition. 

 

 

 

Yamato Scientific Co., Ltd. 

Reviews: