background image

An ASSA ABLOY Group brand

P/N 80-9510-0056-010 Rev B

4800LN GRADE 2 INTERCONNECTED LOCKSET
INSTALLATION INSTRUCTIONS

Installation of this product requires that two 2 1/8" holes are spaced 4" apart center to center. See the hole template
sheet for accurate hole locations.

Interior Mechanism Housing

Connecting Screws

Installation Plate

Latch

Deadbolt Latch

Deadbolt

Hub with Square Spindle

Tailpiece

Summary of Contents for 4800LN

Page 1: ...LATION INSTRUCTIONS Installation of this product requires that two 2 1 8 holes are spaced 4 apart center to center See the hole template sheet for accurate hole locations Interior Mechanism Housing Connecting Screws Installation Plate Latch Deadbolt Latch Deadbolt Hub with Square Spindle Tailpiece ...

Page 2: ...n then tighten all four connecting screws Reinstall the interior mechanism housing on the installation plate with the two self thread screws saved before Once this operation is done the square spindle for the interior mechanism housing is inside the hub of the lower latch and operates the latch Note that the thumbturn must be in the vertical position then slide the lever over the bottom tube and p...

Page 3: ...mm hole halfway through door Finish bore from other side to prevent splintering 4 To mark strike location close the door and push locator pin through both guide holes marking the strike plates center position 5 Bore 2 holes 1 25mm through the door edge 6 For handleset installation only Bore 5 16 hole to receive bottom portion of handleset 7 Insert the latch and then trace outlines of latchplates C...

Page 4: ...ctions P N 80 9510 0056 010 Rev B REMOVAL OF CYLINDER When not installed on door REMOVAL OF CYLINDER When installed on door Remove the loose plate from the back of the cylinder Two screws hold a metal strap in place Under the C cutout in this strap is a semicircular indention in a spring loaded tab Using the cylinder removing tool wire with loop or a screwdriver place the tip of the tool against t...

Reviews: