Wyse Terminal
370
IBM Document: Wyse
08/97 Doc # WYSE002
Page 1 of 2
Copyright International Business Machines, 1997
All rights reserved
Figure 1: Wyse 370 Color Terminal
Specifications
Standard Features
•
64k display for 26 x (80, 132) with 2 row status
•
14” diagonal monitor with .28mm dot pitch
•
Dual-session capability
•
64 independent screen colors for fore/back-ground
•
Application Specific Integrated Circuit (ASIC) gate array
with a 8 Mhz 68000 processor chip.
•
Pull-Down Setup Menus
•
WyseWorks -- Integrated desktop applications such as:
Datebook / Calendar, Calculator, Alarm Clock
•
Multi-Language Keyboards
•
Variable Scroll Speed
•
Screen Saver
•
Two Serial Ports ( A & B )
•
Refresh rates: 74Hz Alpha mode or 65Hz graphic mode
•
Tilt and Swivel Base
Optional Features
•
256k display for 52 x 161 display or 8 page display
Operating Modes
•
Setup
•
On-Line
Full or Half Duplex
Block or Half-Block Mode
Printing: Normal, Auto Print, Controller Print
•
Local or WyseWorks
Interfaces
•
Port A:
RS-232 / RS-422, Female DB-25, 76.8 K
baud
•
Port B:
RS-232, Female DB-25, 38.4 K baud
•
Keyboard: ANSII, ANSI, EPC
•
Cartridge Slot
Dimensions
•
Footprint: 11.5” w X 11.0” d
•
Display:
14.0” w X 14.5” d X 13.5” h
•
Weight:
45 lb.
Power
•
120 VAC
±
10% @ 47-63 Hz.
Emulations
•
ANSI
Wyse 370, ColorTrend 220
DEC VT52, VT100, VT220, VT320
•
Graphics
Tektronics 4010, 4014
•
ASCII
Wyse 350, TVI 950, Esprit III, ADDS A2
Special Notices
•
Dual sessions are N/A with both Tektronix emulations.
•
XMT handshake should never be used with ADDS, Data
General, and PC graphics personality terminals.
•
Signal ground is always internally connected to the
frame ground on all Wyse terminals.
•
Hardware handshaking for all terminals is always:
Busy = Low / Ready = High.
•
If a printer uses a variable input buffer level, setup the
printer to handshake at the lowest level possible.
•
All terminals utilize one start bit for operation.
•
Maximum distance for serial cable is fifty feet but with
shielded cable it may exceed this distance.
Tools Recommended
•
#1 Phillips Screwdriver
•
Small straight-blade screwdriver
•
Compressed air or vacuum cleaner
Keyboard Commands
Function
ASCII
ANSI
EPC
Enter Setup Mode
Setup
F3
Select
Toggle Block Mode
Ctrl / Shift
Break
Shift F5
Ctrl / Shift
Break
Toggle Auto Print
Ctrl / Print
Ctrl / Shift F2
Ctrl / Print
Print Screen
F2
Print Screen
Error Codes
Error Codes**
Explanation
9
Battery-backed RAM checksum error
P
Code ROM checksum error
G*
Cartridge 1 ROM set error
H*
Cartridge 2 ROM set error
u xx xxxxxx xx xx
RAM error
* When optional cartridge installed, indicates malfunction
** To clear error messages enter “Setup Mode” then exit.
