Revision: 09/2014
W 3552-6.02e.E
Page 1 / 16 MWi
Instruction manual
BDP2
Please read this manual carefully before installing, commissioning or operating the BDP2
1.
INTENDED USE
The automatic oil return system BDP2 is solely intended to return refrigerant oil in a
refrigeration or heat pump system.
2.
SAFETY REQUIREMENTS
Any work with refrigeration systems must be carried out by trained and knowledge-
able personnel. All safety regulations / EC-Material Safety Data Sheets and codes
of practice concerning the use of refrigerants must be adhered to.
Under no circumstances are the indicated temperature- and pressure-limitations on
the data plate to be exceeded!
Applicable standards and regulations for installing or operating refrigeration plants,
e.g., EN 378 must be adhered to.
Before work is carried out and screws are loosened, it
is important pressure has been entirely released from the BDP2
housing.
When opening the BDP2 a sudden evaporating of trapped refrigerant
may occur. Therefore, special attention must be paid to wearing pro-
tection clothing and safety glasses.
ATEX
The BDP2
without optional level sensor
has no ignition sources and therefore it does not meet the definition of
devices according to the ATEX Directive 94/9 / EC. The basis for this is an risk assessment of ignition sources ac-
cording EN 13463-1, chapter 5.2. Even during possible occurring malfunctions there are no own potential ignition
sources present.
3.
TERMS OF WARRANTY
To prevent accidents and for the safe operation of the refrigerant plant no modifications or alterations may be carried
out to the BDP2 without written approval by TH. WITT Kältemaschinenfabrik GmbH.
All information for the safe operation and maintenance of the BDP2 is based on our experience and is to the best of
our knowledge.
Our liability or warranty is excluded, if:
The instructions in this manual are not adhered to
The BDP2 and its equipment were operated incorrectly or the handling was not in accordance with the
mentioned procedures
The BDP2 is used for purposes other than that for which it was intended to
Safety devices were not used or disconnected
There have been modifications made without written approval
The safety requirements were not adhered to during installation or operation
