background image

Caution!
Safety indications:

1.Before operation it is absolutely necessary to read carefully
this instruction and especially the safety indications.

2. This remote control device is exclusively meant and authori-
zed for the operating of RC-steam models by Wilesco. Wilhelm
Schröder GmbH & Co.KG assumes no liability in case of diffe-

rent use.

3. For safety reasons, children (recommended age: from 12 years on) should
operate this remote control only under supervision of adults

.

4. Operating this remote control requires technical knowledge cautious acting. Faults
or carelessness during installation and operation can result in considerable damage to
property or persons.

5. Also operating the receiving device without the radio transmitter online can cause
problems or injuries.

6. In case of abnormal operation it is expressly referred to these dangers, any warranty
expires.

7.Each irregularity during operation must exclusively be repaired by a competent and
authorized person or by WILESCO themselves. Otherwise any warranty expires.

Nonwarranty clause

8. Since it is impossible to control handling, respect of installation and operation hints,
application and maintenance, Wilhelm Schröder Gmbh & Co.KG assumes no liability
for loss, damages or costs. Any claim for compensation resulting from operation,
application or remote damages is refused. No liability is assumed for damages to
persons or property or for consequences.

9. Unless legally admitted and regardless of the cause in law

the obligation to

indemnification is limited to the invoice value of the product which is immediately
concerned with the event.

10.

It is absolutely necessary to keep this operating instruction.

Operating instructions

11. Unscrew the cover
of

the

battery

compartment and insert
a

9-V-monobloc

battery. Fix the cover
with

the

screw

and

screw the antenna in the
thread.

12.

Switch

on

the

transmitter

(position

on). The LED has to
come

up.

The

right

switch controls the right
/ left direction, the left
switch

controls

the

forward

/

backward

direction.

13. Unscrew the cover
of

the

battery

compartment

and

insert

2

1,5-V-

batteries type AAA
(observe

correct

po/-). Fix the
cover with the screw.

14.

Only

for

supplementary

set

Z363 to steer forward
and

backward:

connect up the jack
plug.

15. The relevant installation instruction is described in the notes of each model (pages
3 - 6).

Use of batteries

16. Non-rechargeable batteries are not to be recharged.
17. Different types of batteries or new and used batteries are not to be mixed.
18. Only batteries of the same or equivalent type as recommended are to be used.
19. Batteries are to be inserted with the correct polarity.
20. Exhausted batteries are to be removed from the toy.
21. Supply terminals are not to be short-circuited.

Telecommunication regulations

22. Please observe the telecommunication regulations in the country in which you
want to drive your model.

The user is responsible for the due use of the radio

remote control. Please observe the legal situation in your country.

Indication of waste disposal

23. Environment protection also concerns Wilesco. You have the possibility to return
to us the remote control and also the original packing (freight charges are

not

reimboursed). All returned remote controls / packing are professionally recycled. You
can also dispose of the electronic components professionally and according to the legal
prescriptions yourself by taking them to the recycle boxes in your community.

This model is meant for the above described purpose only.

Technical specifications subject to change without prior notice.

Schützenstraße 12

E-Mail: [email protected]

D-58511 Lüdenscheid

www.wilesco.de

Remote Remote Control Z360

forward

backward

only with
supplement Z363

right

left

only with supplement Z363

Summary of Contents for Z360







Reviews: