24 Hour Mechanical Timer
2 Polarized Outlets and Plug
Rated: 125VAC/60Hz/15A/1875W Resistive
10A/1250W Tungsten
1/2 HP Motor Load
INSTRUCTIONS:
1. Locate an electrical outlet that is close to the device you want
to control.
2. Put the WHITE “ON/TIMER” switch located on the side of the unit to
the “TIMER” position and plug the timer into the outlet.
3. Set the current time - turning clockwise, align Arrowhead
(see diagram) on the face of the timer to the present time (lines under
numbers are in increments of 30 minutes). There is no need to touch
the pins to set current time.
NOTE:
Dial is based on AM/PM.
4. Determine desired start time and push down all pins until desired OFF
time. The timer pins are factory preset in the “pushed down” or “ON”
position. Pull up all of the pins before pushing down pins for your
desired “ON” time.
NOTE:
The “pins” are grey slices around the dial.
For example:
to turn the timer ON at 5pm and OFF at 10pm, push
down all the pins between 5pm and 10pm.
5. Plug your electrical device directly into the timer. The electrical device
must be set to “ON” position for the timer control to work properly.
6. The WHITE switch on the timer must be set to the Timer (bottom)
position for the timer function to work.
You may override operation of the timer by setting the WHITE
“ON/TIMER” switch (located on the side) to ON (top position). Be sure to
set switch back to the TIMER (bottom position) for proper timer function
In case of power failure, reset the time of day as indicated in steps 3
above.
LIMITATIONS OF TIMING DEVICES:
Timing devices require power to function properly. If AC power to the timer
is cut off, a light or other device plugged into the timer will not work.
WARNING:
• For indoor use only. Do not use in wet, oily, or high-temperature
conditions.
• Do not plug this timer into an extension cord or other electrical adapter.
Plug directly into an electrical outlet.
• Do not connect this timer to appliances that contain heating elements
(cooking appliances, heaters, irons, etc.). Failure of the timer to shut off
such devices may lead to overheating and a potential fi re.
• Do not plug in this timer if it is wet.
• Do not clean this timer when it is plugged in.
• Do not exceed the maximum ratings of the timer.
• Potential shock hazard: Keep out of reach of children.
NOTES:
• The device you are plugging into the timer has to be ON.
• Make sure AM and PM are correct on the current time and in the
program settings.
and
WESTINGHOUSE
are trademarks of Westinghouse Electric Corporation. Used under license. All rights reserved.
Manufactured and distributed by: The NCC, Brooklyn, NY 11220 • www.thencc.com • ©2014 The NCC
Made in China
SAVE THESE INSTRUCTIONS!
Customer Service Assistance: Toll Free 1-855-350-6868
Hours of Operation – 10AM to 6PM, EST, Monday - Friday
Item #T28440
Timer pins are factory preset in the “pushed down” (‘ON’) position.
Pull pins up for timers ‘OFF’ intervals.
Pins Down = ON Light/Device
Pins Up = OFF Light/Device
12
11
1
0
9
8
7
6
5
4
3
2
1
1
9
3
1
2
11
10
8
7
6
5
4
2
Pins
Down=ON
Up=OFF
ON
TIMER
