![background image](http://html1.mh-extra.com/html/wesco/terradur/terradur_care-and-use-instructions_957445001.webp)
This kettle has been designed to give you safe and
efficient use and we would ask you to read all of these
instructions carefully to ensure that you obtain the best
results.
The new Terradur®-coating by Wesco
The Wesco Terradur®- waterkettle is made of high-quality
steel and is coated on the outside as well as on the inside
with Wesco Terradur®-coating.
This is an eco-friendly functional coating based on natural
inorganic raw materials. The extremely smooth surface is
easy to clean, heat- and acid-resistant. The Wesco Terra-
dur®-coating is scratch-resistant, nickel-free and eco-fri-
endly due to its durability.
Safety instructions
It is recommended that you do not leave the kettle unat-
tended whilst heating. Please refrain from filling your
kettle above the maximum water level (max. below spout).
Please avoid boiling small amounts of water as this will
cause the kettle to boil dry. In the unlikely event that the
kettle has boiled dry, turn the heat off and allow to cool
before handling. Don’t heat the kettle without water in it!
Handle, lid and whistle may become hot after prolonged
heating. The use of oven gloves or a cloth is advised.
Before placing the kettle on the hob, please ensure that
the lid is pushed down firmly and that the whistle is posi-
tioned firmly on the spout. This will ensure that sufficient
pressure is able to build up and cause a whistle at boiling
point. Be cautious when removing the lid or the whistle
immediately after boiling as the steam escaping from the
kettle may hurt your hands. Remove the whistle laterally
to avoid the escaping steam.
Before use
Ensure all labels and stickers are removed. Before first
use, fill the kettle with cold water to the maximum filling
level below the spout. Boil for two minutes. Allow to cool
and empty the kettle. This procedure should be repeated
two times. After that wash in warm soapy water, paying
particular attention to the inside rim of the kettle body,
lid, spout and whistle. Rinse and dry thoroughly.
CARE AND USE INSTRUCTIONS
WESCO TERRADUR
®
- WATERKETTLE
WESCO - M. Westermann & Co. GmbH
- Bahnhofstr. 205 - D-59759 Arnsberg
Tel. +49 (0) 29 32/4 76-0, Fax. +49 (0) 29 32/4 76-55 - [email protected] - www.wesco.de
04/2015
During use
Select heating ring to correspond with the size of the base
of the kettle and place the kettle on center of the burner.
Please use medium flame resp. heat setting on every kind
of hob (gas, electric, ceramic-top, induction). Do not use
high temperature settings! On gas hobs make sure that the
flames are not allowed to extend up the sides of the kettle.
This might damage the plastic parts of the kettle.
As soon as the water is boiling (upon whistling tone) the
kettle can be removed from the hob. Please wait 10 - 20
seconds after boiling before pouring out the water. After
the kettle has been used, allow it to cool before filling cold
water in it.
For cleaning the kettle we recommend dishwashing liquid
and water, a dish-cloth or a non-abrasive sponge. Do not
use abrasive cleaners. Rinse and dry thoroughly. Cleaning
in the dishwasher is not recommended.
Mineral deposits in the kettle can be easily removed by fil-
ling the kettle half with water and adding the juice of half
a lemon and two tablespoons of baking soda. Then boil the
water for approx. 4 - 5 minutes. After that rinse and dry
thoroughly.
If you comply with these care and use guidelines they will
ensure that you enjoy successful and long lasting use of
your kettle.