Removing & Connecting the Camera
1.
The camera is stored at the back of the unit, along the bottom. With
the unit facing towards you, run your fingers 1 inch (2.5cm) up the
back of the left edge. You will feel a half circle shaped cut-out. Push
the camera head backwards via this recess & fully remove it.
2.
Unfold the camera
3.
Locate the camera slot, positioned on the top of the unit, at the
front, 1.4 inches (3.5cm) from the left-hand side.
4.
With the shorter arm (containing the USB port) facing downwards &
the other part of the arm facing towards you, angle the camera
head a few degrees forwards & gently insert into the camera slot.
Plugging In
Plug the tip of the power brick into the unit’s
power socket, located on the rear of the unit,
on the far-right hand-side, 2.5 inches (6cm)
up (a round area with a round recess).
Ensure the power brick’s cable is plugged in
and connect it to the mains.
Quick Reference
Guide v1.0
