1.
Position Vaportronic 2.0 on wall where unit is to be mounted &
mark top of unit. Allow at least
3”
clearance above unit for
hinged cover to lift open.
2.
Measure 1.25" down from mark & drill top mounting hole using
3/16" drill bit.
3.
Insert supplied anchor into hole & insert supplied screw into
anchor leaving a 1/8" protrusion.
4.
Using supplied Allen wrench, open unit by removing bottom
screw. Open cover & hang unit on top mounting screw.
5.
Mark bottom hole using hang hole in back panel, remove unit,
& drill bottom mounting hole using 3/16" drill bit. Insert
supplied anchor into hole.
6.
Hang unit on top mounting screw & align with bottom
mounting hole. Insert supplied screw into anchor & securely
tighten.
7. Insert 2 AA batteries.
1.
Open protective bag containing EZ
-
Disk by tearing at notch.
Gently press EZ
-
Disk down & back into slot(s) to prevent
element interference with fan.
2.
Install 1
-
5 EZ
-
Disks depending on your cubic footage needs.
Each EZ
-
Disk treats 2,000 ft
3
.
3.
Ensure slide switch is turned ON & adjusted to desired setting.
Use setting 1 when maximum dry vapor output is required.
4.
Close lid & reinsert bottom screw using Allen wrench.
5.
Wash hands with soap & water to remove any residue
from handling EZ
-
Disks.
DEODORIZING ELEMENT INSTRUCTIONS
WALL
-
MOUNTING INSTRUCTIONS
May be used free
-
standing
or wall
-
mounted.
USE AND OPERATING
INSTRUCTIONS FOR THE
VAPORTRONIC 2.0
™
Vaportronic 2.0
Refillable, Electronic
Wall Cabinet System
0
-
0FF
Setting 1
-
One minute ON, 5 minutes OFF
Setting 2
-
One minute ON, 10 minutes OFF
Setting 3
-
One minute ON, 15 minutes OFF
