3
1
4
2
BALL VALVE SERVO
INSTALLATION
BALL VALVE SERVO INSTALLATION GUIDE
Do NOT use on other types of valves.
1. CLOSE VALVE
2. PREPARE YOUR BVS
3. INSTALL BVS ON YOUR VALVE
4. CONNECT SPC AND POWER ADAPTER
Touch Sense Button
if you
have
oversized
valve
or your valve has
adjacent pipe elbow
,
you
may
slide any or both clamps in or out to fit the space.
1
Make
sure
the
knobs
are
facing
on the same
side
as
the
water
valve
handle
2
Check the transmission fork mechanic engagement by visual
You SHOULD
NOT see the PATTERN
on the top of transmission fork, if you do, you
may not install it securely, please double check, make sure you have pushed the BVS
down enough for a secured installation.
Otherwise you have a rare ultra low profile valve, the handle is too low for spring
loaded mechanic to engage, in this case, please put the Spacer between the hex
bolt head of the valve and the transmission fork.
If you don’t see the pattern without Spacer, DO NOT use the Spacer.
PATTERN NOT SEEN
PATTERN SEEN
Rotate the handle from position to position to turn off your valve
1
2
Align the pivot of the transmission fork is with the hex bolt
on top of the valve Press down firmly to engage the spring
loaded gear, then tighten 2 clamps.
Position the BVS over the top of the handle of ball valve
1
2
1
2
If you are installing the Ball Valve Servo outdoor, you may consider to disable the
touch sensing button to prevent it activated from rain drops or pets.
To Disable the button:
Tap and hold the touch sense button for 3 beeps, then quickly tap 3 times in a row.
If successful, the Yellow LED will flash once, then the Red LED with 1 beep. The LED
will slowly flashing Yellow indicating the touch sense button has been locked.
To Re-Enable the button:
Tap and hold the touch sense button for 3 beeps, then quickly tap 3 times in a row.
If successful, the Yellow LED will flash once, then the Red LED with 3 beeps. LED will
then slowly flashing Green (if enrolled) indicating the touch sense button has been
unlocked.
PACKAGE
CONTENTS
Ball Valve Servo (BVS)
Water Detection
Probe 55.1 inch
3
4
1
2
Power Adapter
Spacer
1
You
may install local water detection probe
(included)
for close area leak detection
,
plug the male
jack to the female jack from the power supply cable branch, It
will trigger the valve to close
whenever water is detected. (remove the protection cap from female jack first)
1
2
2
if you have purchased Smart Power Capsule, connect it
between Ball Valve Servo and power adapter. SPC is the
optional back up power device, it provides up to 32 hours of
back up power for BVS if there is a power failure.
Insert the male jack into the
water tight female jack
with
extra force
to secure contact and
water proof result
1
2
