background image

Ubee Interactive — www.ubeeinteractive.com 

 

 

 

  Ubee DVW32G6 – Safety and Installation Product Insert v1.0 

DVW32G6 Advanced Wireless Voice 
Gateway - Safety and Installation 
Product Insert 

 

Federal Communications Commission 
(FCC) Interference Statement

 

This  equipment  has  been  tested  and  found  to 
comply with the limits for a Class B digital device, 
pursuant  to  Part  15  of  the  FCC  Rules.  These 
limits  are  designed  to  provide  reasonable 
protection  against  harmful  interference  in  a 
residential installation. This equipment generates, 
uses and can radiate radio frequency energy and, 
if  not  installed  and  used  in  accordance  with  the 
instructions,  may  cause  harmful  interference  to 
radio  communications.  However,  there  is  no 
guarantee  that  interference  will  not  occur  in  a 
particular  installation.  If  this  equipment  does 
cause  harmful  interference  to  radio  or  television 
reception,  which  can  be  determined  by  turning 
the equipment off and on, the user is encouraged 
to  try  to  correct  the  interference  by  one  of  the 

following measures:

 

 

Reorient or relocate the receiving antenna 

 

Increase  the  separation  between  the 
equipment and receiver. 

 

Connect the equipment into an outlet  on a 
circuit  different  from  that  to  which  the 
receiver is connected.   

 

Consult  the  dealer  or  an  experienced 
radio/TV technician for help. 

FCC Regulatory Information

 

This  device  complies  with  Part  15  of  the  FCC 
Rules.  Operation  is  subject  to  the  following  two 
conditions:  (1)  This  device  may  not  cause 
harmful  interference,  and  (2)  this  device  must 
accept  any  interference  received,  including 
interference that may cause undesired operation. 

There is one statement for this product:   

  Only the type of PCB antenna tested may be 

Summary of Contents for DVW32G6









Reviews: