U-STEP Cueing Module User Guide
In-Step Mobility Products
www.Ustep.com
Installing and Replacing the Battery
The battery is installed as shown below. Remove the small screw holding the battery cover on (Figure
1), and slide the cover to the left to remove it. Replace the two “AA” batteries shown in Figure 2 with
Alkaline or Lithium batteries. Make sure the two batteries are installed in opposite directions, with the
“+” and “-“ sides. The unit will beep either three or five times then the batteries are installed correctly.
If the unit beeps three times, the unit is shutting off; if the unit beeps five times, the unit is turning on
and the LED indicator will start to blink.
Figure 1
Figure 2
Operating the Unit
Operate the unit from the control unit mounted on the right handle bar in Figure 3. If the unit is off,
pressing the red ON/OFF button on the control unit and it will go on. The unit will beep 5 times, the
power indicator will begin blinking, and the laser will turn on. If either button is pushed again, the unit
will beep three times and turn off.
To activate the sound cueing, turn on the laser and then press and hold the top black ON button
beneath the AUDIO label on the left of the module (Figure 3). After a few seconds of holding, the
auditory cueing will engage. When auditory cueing is enabled, pressing the FAST key will increase the
cadence and pressing the SLOW key will decrease the cadence. The cadence varies from 59 to 130
beats per minute over 15 increments. To turn off auditory cueing, press and hold the SLOW button.
To adjust the volume, turn on the laser and then press the SLOW button (Figure 3). The volume will
decrease each time the button is pushed. When the softest level is reached, the volume then revert to
the loudest level and decrease again with each button push. The volume level selected will remain in
effect for subsequent use.
