Tyre Inflator
User Manual
Packing List
1x Inflator
1x Air Tube
1x Presta Valve
Convertor
1x Ball Inflation
Needle
1x USB Charging Cable
1x Storage Bag
Details
UNIT ‘U’ Button
- Button + Button LED Screen POWER Button
+
-
U
Short Press Choose Unit Reduce Pressure Increase Pressure Start/Stop Inflating
Long Press Turn On/Off Light Quick Reduce Quick Increase
Turn On/Off
About Buttons
About Inflation
Reference Pressure Time from Empty (Minutes) Frequency from Empty
Car
Road Bike
Mountain Bike
Motorcycle
Basketball
*No extrusion during testing
2.3
–
2.5 BAR
100-120 PSI
30-50 PSI
30-50 PSI
7-9 PSI
8-12
2-3
2-3
2-3
0.5-1
2-3 (205 55R17)
8-12 (700x23C) *
12-18 (26x1.95) *
8-12
30-40
LED Light
Vent Port
Air Tube Storage
USB Charging
Port
Charging Indicator
Steps for Inflation
1. Connect one end of the air tube to the inflator, connect the other end to the tyre valve
(for presta valve please install the valve convertor first).
2. Long press the POWER button until the LED screen lights up. The LED will show the current set pressure.
3. Press the UNIT button to choose the pressure unit between PSI, BAR, KPA and kgf/cm².
4. Use the ‘+’ button and ‘
-
’ button to set the target pressure. The inflator will remember the pressure you set previously.
5. Press the POWER button to start inflating. Pressing it again can pause or continue.
The inflator will stop automatically when it reaches the target pressure.
Using the Torch -
Long press the UNIT button to turn On/Off the LED light.
About Charging
1. For first time use or after a long time of no use please charge the inflator before using.
2. The charging indicator will turn red during charging and the indicator light will turn red and green alternately
when charging is complete.
3. Usually the inflator should be charged every two months even when it will not be used.
If you do not charge the inflator for a long time the battery will be over-discharged and the battery may become damaged.
