PAGE 1 OF 39
0318 IH-7095
π
H-7095
DIGITAL
MULTIMETER
1-800-295-5510
uline.com
SAFETY
To ensure the safe operation and service of the meter,
follow these instructions closely. Failure to observe
warnings can result in severe injury.
WARNING! When handling test leads or probes,
keep hands and fingers behind the finger
guards at all times.
• Remove test leads from the meter before opening
the battery compartment or meter housing.
• Use the meter only as specified in these instructions
to avoid compromising the protections provided by
the meter.
• Be sure to use the proper terminals, switch positions
and ranges when taking measurements.
• Verify the meter’s operation by measuring a
known voltage. Have the meter serviced if the
meter responds unusually or if there are questions
regarding the meter’s functional integrity.
• Do not apply more than the rated voltage, as
marked on the meter, between terminals or between
any terminal and earth ground.
• Replace blown fuses with fuses of the same type
and rating as specified on page 10.
• Use caution working with voltages above 30 VAC
RMS, 42 VAC peak, or 60 VDC. These voltages pose
a shock hazard.
• To avoid misleading readings that could lead to
electric shock and injury, replace the batteries as
soon as the low battery indicator is displayed.
• Disconnect power to the circuit under test and
discharge all high voltage capacitors before testing
resistance, continuity, diodes or capacitance.
• Do not use the meter in the presence of explosive
gas or vapor.
• To reduce risk of fire or electric shock, do not use
the meter if it is wet and do not expose the meter to
moisture.
• Individual protective equipment should be used
if hazardous live parts in the installation where
measurements are to be carried out could be
accessible.
CAUTION! Do not expose the meter to extremes
in temperature or high humidity.
• Disconnect the test leads from the test points before
changing the position of the function (rotary) switch.
• Do not expose the meter to extremes in temperature
or to high humidity.
• Never set the meter to the resistance, diode,
capacitance or amp functions when measuring the
voltage of a power supply circuit; this could result
in meter damage and damage to the equipment
under test.
Para Español, vea páginas 14-26.
Pour le français, consulter les pages 27-39.
