Glamorca Roller clean 200
–
instruction
Roller clean
is a filtering device that mechanically
removes impurities from water, so that it works
properly, read the instructions carefully.
1. Roller consists of 2 main components:
a) the holder to which we connect the hydraulics
and hang it on the edge of the aquarium,
b) cassettes with filter fleece.
2
. CAUTION!!! For transport, the roller's slings
were mounted the other way round, unscrew the
4 black screws on the side of the casing, turn
the handles and screw them back on.
3.Before assembly, remove the cassette from the
holder. The immersion level of the device is marked
on the front. The slings on the side of the device
regulate the draft.
For the device to work proper-
ly, the water level must not exceed 10mm from
the marked line (4)
4. On the left or right side, we can install a 32mm
bend (
5)
, to which we connect the water drain. On
the opposite side, screw the round cap
(6).
Approximately 2 cm from the upper edge of the
handle, there is an overflow hole for safety.
5. After mounting the handle, we prepare a non
-
woven cassette. On the side of the cassette there is
a diagram of the non
-
woven fabric routing between
the rollers. We put it on the lower handle with a
diameter of 16mm
(2)
and lead it between the
rollers, up to the upper roller with a motor with a
diameter of 50mm
(1). The cable from the motor
should come out as shown in the diagram (3)
Attention!
The non
-
woven fabric should be
attached to the roller with the motor with a sticker
which is attached to the new roll marked
Roller clean
200
, the non
-
woven fabric should be placed on a roll
with a diameter of 50mm, and after turning the
motor by a full turn, the non
-
woven fabric will tighten
on the motor.
There are 3 pieces of information on the controller:
•
green
LED
-
operation, the controller, after
receiving the signal, rewinds the roll of non
-
woven fabric,
•
blue
LED
-
sensor blocked, the controller has
received too long information that the sensor is
lifted, although it is scrolling the fabric,
•
red
diode
-
engine lock, the controller monitors
the engine power during operation, stops it when
it is overloaded.
Any error is reset by
disconnecting the power
supply from the 230V socket for 1 minute.
Before
restarting, you should diagnose what caused it
The engine lock error is saved in the controller
memory, it may be caused by:
-
installation of non
-
original non
-
woven fabric,
-
too high water flow,
-
failure to install the roller in accordance with the
instructions or intended use,
-
too many snails or other hard debris on the runoff.
Too many motor errors (red LED) can damage the
motor or the power output in the controller. After
reading the number of errors, the service decides
whether the device was used for its intended
purpose and decides on a warranty repair.
There is a
MANUAL WORK
button on the
controller, thanks to which we can scroll the roll of
non
-
woven fabric manually.
8. After initial setting and starting the roller, leave it
for a few hours and observe the dirt of the non
-
woven fabric.
6. After installing the fleece on the cassette, the
whole thing is put into the holder mounted on the
edge of the aquarium.
7. The next step is to connect the liquid level sensor
(yellow band), motor (red band) and the power
supply to the controller.
The controller should be
placed in a dry place with humidity below 50%.
