GAS Fireplace, AGP Pellet Stove or GAS Insert Remote Control Installation Instructions
(LEAVE THE INSTRUCTIONS FOR THE HOMEOWNER)
The Thermostat Wall Wireless Transmitter is a six button transmitter, which turns the GAS Fireplace, AGP
Pellet Stove or GAS Insert ON/OFF manually or acts as a thermostat. The display of the transmitter shows
the clock, current room temperature, target temperature, timer setting, on/off status, low battery indicator and
“*child-proof*”.
Installation Precautions
:
The Thermostat Wall Wireless Remote Control is tested safe when installed in accordance with this
installation manual. It is your responsibility to read all instruction before starting installation and to follow
these instructions carefully during installation.
The Thermostat Wall Wireless Remote Control MUST be installed by a qualified service technician.
The Thermostat Wall Wireless Remote Control is carefully engineered and MUST be installed only as
specified. If you modify it or any of its components, you may possibly cause a fire hazard.
FCC Requirements
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user authority to operate the equipment. This equipment has been tested and
found to comply with the limits for a Class B digital device, pursuant to Part 15 to the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiver antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio TV technician for help.
Canadian Equipment Requirements
This digital apparatus does not exceed the (class A/Class B)* limits for radio noise emissions from digital
apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. Le
present appareil numerique n'met pas de bruits radioelectriques depassant les limites applicables aux
appareils numeriques (de la class A/de la class B)* prescrites dans le Reglement sur le brouillage
radioelectrique edicte par le ministere des Communications du Canada.
This device complies with RSS-210 of Industry and Science Canada. Operation is subject to the following
two conditions : (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
All wiring should be done by a qualified electrician and shall be in compliance with local codes and with the
National Electirc Code ANSI/NFPA No. 70-current (In the United States), or with the current CSA C22.1
Canadian Electirc Code (in Canada).
Page 1 of 3
99300687
Thermostat Wall Wireless AGP Pellet Stove
GAS Fireplace, Pellet or GAS Insert Only
