background image

www.TrailFX.com

 

Page 

1

 of 

4                                                                                                                                                                                                             

Rev 031618 

 
 
 
 

PARTS LIST: 

Qty 

Part Description 

Qty 

Part Description 

Replacement Bumper 

12×37×3mm Flat Washers 

5×20mm Phillips Screws 

12mm Lock Washers 

5x15x1.2mm Flat Washers 

12mm Hex Nuts 

5mm Lock Washers 

12×50mm Hex Bolts 

5mm Hex Nuts 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Replacement Front Bumper 

Part No. FX3001 

 

Fits: 

2008-2010                  

 

Ford Superduty 

 

ASSISTANCE IS RECOMMENDED.

 

 

         REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. 

         READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. 

         DO NOT OVER

 

TORQUE

.

 STANDARD OPERATING LOAD FOR TIGHTEN   

         BODY MOUNT NUTS & BOLTS VARIES FROM 

45

 TO 

65

 FOOT POUND. 

 

60-180 min

 

     [email protected]

 

      1 866 638 4870

 

    POLISHED STAINLESS STEEL 

– LIMITED LIFETIME 

    POWDER COATED BLACK 

– 3 YEARS 

Cutting Not  

 Required 

Drilling Not 

Required 

Summary of Contents for FX3001

Page 1: ...ts Replacement Front Bumper Part No FX3001 Fits 2008 2010 Ford Superduty ASSISTANCE IS RECOMMENDED REMOVE CONTENTS FROM BOX VERIFY ALL PARTS ARE PRESENT READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION DO NOT OVER TORQUE STANDARD OPERATING LOAD FOR TIGHTEN BODY MOUNT NUTS BOLTS VARIES FROM 45 TO 65 FOOT POUND 60 180 min support trailfx com 1 866 638 4870 POLISHED STAINLESS STEEL LIMITED LI...

Page 2: ...cle Preparation 1 Disconnect the factory fog lamp connectors zip tie harness to frame 2 Remove fasteners holding OEM bumper to chassis 3 Remove fastener holding hood release lever to OEM bumper 4 Remove OEM bumper assembly Bumper Installation 1 Remove the fog light from the vehicle Use the OEM screws and nut plates to fasten the fog light to the bumper Fig 1 Fig 1 ...

Page 3: ...e reinstall the hood release lever into the bracket on the bumper Fig 4 5 Reinstall the factory wiring harness to the fog light 6 Level and adjust the bumper make sure that all hardware is secure and tight 7 Installation is finished pick up all tools Fig 4 Fig 2 4 5mm Lock Washers 4 5 15 1 2mm Flat Washers 4 5mm Hex Nuts 4 5 15 1 2mm Flat Washers 4 5 20 Phillips Screws Fig 3 2 12 50mm Hex Bolts 4 ...

Page 4: ...ist 6 Product not installing properly Ensure make model year cab length and bed size of your vehicle is listed in the application All installation steps are followed correctly Check out these other TrailFX Products www TrailFX com PRODUCT CARE Periodically check the product to ensure all fasteners are tight and components are intact Regular waxing is recommended to protect the finish of the produc...

Reviews: