‒
1
‒
INSTALLATION MANUAL
To Quali
fi
ed Installer in Installation Work and Service
Wireless receiver kit
Model: RBC-AX33UYP-E
• Thank you for purchasing Wireless receiver kit for TOSHIBA air conditioners.
• Read this manual carefully for correct installation of the Wireless receiver before
starting work.
• After the installation is completed, execute a test run to check for normal operation
and explain how to use and maintain the Wireless receiver to the customer according
to the Owner’s Manual.
Ask the customer to keep this manual with the Owner’s Manual.
Observe the safety precautions described in the Installation manual supplied with the
ceiling panel and air conditioner (indoor unit).
Accessories
Part Name
Q’ty
Wireless receiver
1
Wireless remote
controlle
1
Remote controller
holder
1
Part Name
Q’ty
Operation Manual
1
Installation Manual
(this manual)
1
CD-ROM
1
Batterry
2
Flat head wood screw
Ø3.1 x 16R
2
Settings for the Wireless receiver before installation
Before installing the Wireless receiver, make the following setting referring to each
description.
• To install the wireless remote controller together with wired remote controller,
con
fi
gure the “Multiple remote controller installation”
• When ceiling height exceeds the standard height (factory default), refer to the
“Installing indoor unit on high ceiling” on installation manual of the indoor unit.
How to install the Wireless receiver
Install the Wireless receiver
in correct orientation, since
the Wireless receiver can be
installed at only one corner
as shown in. (Fig. 1)
1.
Remove the adjust corner
cap at the corner where the
Wireless receiver is to be
installed. (Fig. 2)
• Pull the edge of the adjust corner cap
in the direction of arrow.
• Remove strap from the pin and detach
the adjust corner cap from the ceiling panel.
(Fig. 2)
Pull
Adjust corner cap
Ceiling panel
Pin
Strap
2.
Wiring the wireless receiver lead wire through to the clamp in the back side of the
ceiling panel.
Wireless receiver wire
Clamp
Clamp
3.
Attach the Wireless receiver cap to the ceiling panel.
• Hook the strap of the Wireless receiver cap securely to the pin.
• Insert the two claws A of the Wireless receiver cap into the rectangular holes of the
ceiling panel in the direction of arrow.
• Push the Wireless receiver cap so that the two claws B
on the back of the cap are
fi
tted.
Pin
Claws A
Claws B
Wireless receiver cap
Strap
Push
CAUTION
Press the two claws B of the adjust corner cap
fi
rmly as far as they will go, and
then check that the adjust corner cap is closely attached.
Failure to do so may result in water leakage.
4.
Connecting wires of Wireless receiver.
• Remove the screw of the electrical control box cover, and detach the electrical
control box cover by slide.
(The eletrical control box cover is clamped onto the hinge.)
• Pass the wireless receiver wire from the ceiling panel through the clamper as shown,
and connect the wire to connector CN214 on the P.C. board of the indoor unit.
* Connect the wire
fi
rmly to the connector to ensure operation of the Wireless
receiver.
• Attach the electrical control box cover by reversing the procedure of detaching.
* Make sure that no wire is caught between the electrical control box and the
cover.
* Make sure that no wire is caught between the indoor unit and the ceiling
panel.
Electric control
box cover
CN214
Clamper
Pass the wire
through the clamper
as illustrated.
Wireless receiver wire
Screw
Wire Connection (For illustrative purpose the orientation of the indoor unit is not the actual orientation)
(Fig. 1)
Wireless receiver
installing position
(English)
