Assembly Instructions
LabMaster 10Zi Rack Mount
Thank you for purchasing a Teledyne LeCroy LabMaster 10Zi Rack Mount accessory. The following procedures explain proper
installation of the rack mount.
Upon receiving your shipment, remove all parts from the packaging. Refer to the Parts Table to ensure that all items have shipped
correctly, and contact us immediately if any parts are missing.
CAUTION.
The LabMaster 10Zi system performance depends on adequate airflow into the vents on the bottom cover of
the units. When installing in a rack, do not position the units so as to block the vents. Any equipment or debris in the 1
inch (25.4 mm) space below the units could result in performance degradation and possible shutdown of the system.
Use the provided tools to complete the assembly.
T10 Torx Driver
2.5mm T-handled,
9" long Allen Key
T25 T-handled Torx Driver
MCMZi
Control
Module
Pre-Assemble
Brackets
Pre-assemble
the
brackets
and
handles
into
a
single
piece
using
two
8-32
Undercut
Flat
Head
screws
per
bracket,
as
shown
below.
Right Bracket with 3/8 Offset Handle
Left Bracket with 3/8 Offset Handle
9
33203
-00
Rev
A
1
Environmental Compliance
Unless otherwise specified, all materials and processes are compliant with RoHS Directive 2011/65/EU in its entirety,
inclusive of any further amendments or modifications of said Directive.
Summary of Contents for LabMaster 10Zi
Page 8: ......
