TD-1/11-099
TPL NET Network Module
Installation and User Manual
Issue Date: 25/06/2013
IMPORTANT NOTIFICATIONS
GENERAL
Before operating devices, read carefully this manual and
save it to use later.
Read all notifications and protections carefully that is written
in this manual. Apply all management and using instructions
respectively.
Keep devices away from water and humidity.
ENVIRONMENT CONDITIONS
Do not operate the device out of the limits which are
described below.
Temperature:
between 0
C and +65
C
Humidity:
%95 at +40
C
SERVICE
Do not attempt to repair device yourself. You may expose to
electrical shock if you open the cover.
In case of any malfunction please contact your dealer or
authorized service. Technical response to the device must
be performed by qualified service personnel.
CONDITIONS REQUIRING TECHNICAL SERVICE
Please contact your authorized service or dealer in case of
any malfunction or following cases happen.
If the power cord or plug is damaged,
If any fluid flows or something falls into the device,
If exposed to water or rain,
If device dropped or the cover damaged,
If there is a noticeable performance change on the
device,
If the device do not operating due to management and
using instructions that are described in manual,
Since wrong operations may occur new malfunctions
please contact the authorized service.
SPARE COMPONENTS
Be sure technician use original or equivalent component due
to risk of electrical shock of another malfunction if repair
process will be realized by changing components.
SAFETY CHECK
In order to check if the device operating in secure conditions
or not, request technical service from your authorized dealer.
SPECIFICATIONS*
TPLNET module provides to access and control all VAP
series alarm panels over network, internet, and intranet via
VAPMan software.
Supported Velocities:
10/100 Mbps
Power Supply
12 V DC, 50mA
Username
admin
Password
123456
DHCP Support
Yes
*
Technical specifications may be changed without notification
.
MOUNTING
1. Turn down the energy of the panel completely,
2. Place the TPL NET card coincide with the holes on the
printed circuit board carriers.
3. Stabilize the TPL NET card to the panel by using 4
screws that are inside the box and 4 mounting hole,
4. Plug one side of the connection cable of 4 which is ready
inside of the TPL NET box, to socket on the TPL NET
board that is shown by blue arrow (2).
5. Plug one side of the connection cable of 6 which is ready
inside of the TPL NET box, to socket on the TPLNET
board that is shown by red arrow (1).
6. Plug the other side of connection cable of 6 to the
expansion connector of 6 on the panel.
7. Plug the other side of connection cable of 4 to slot on the
panel. (Slot location on electronic card may vary depends
on type of the panel)
8. Insert the network cable (RJ-45 male connector) to the
socket on TPL NET which is shown by green arrow (3).
9. Turn on the energy of the panel again.
LEARNING IP ADDRESS OF THE DEVICE
As you can learn the IP address of the device via DHCP
server, you can also set by the program CD which is giving
with device located on “TPLNET_FINDER.exe”. When this
program runs, it scans automatically the modules on your
program network and lists them.
CONFIGURATION
TPL NET module is set as DHCP ON in factory. It means if
you have a DHCP server in your system, TPL NET takes its
IP automatically and starts operating without any setting.
Green light on the RJ45 connector shows existence of
network connection (electrically), yellow light shows
existence of communication.
1
2
3
