![background image](http://html1.mh-extra.com/html/te-connectivity/1752786-1/1752786-1_instruction-sheet_3939312001.webp)
Instruction Sheet
1
of 6
© 2017 TE Connectivity Ltd. family of companies.
All Rights Reserved.
*Trademark
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at
408-8958
19 JUL 17
Rev C
Figure 1
1.
INTRODUCTION
This instruction sheet covers application, inspection and maintenance procedures for Hydraulic Crimping Head
PN 1752786-1 shown in Figure 1.
The crimping head accepts interchangeable die sets for a variety of terminals and splices for large wire sizes -
4/0 through 1000 MCM range. Refer to the instructions packaged with the specific die sets for compatible
products, wire ranges, strip dimensions, and application procedures.
This crimping head is designed for use with Foot Hydraulic Pump PN 1583659-1, Hand Hydraulic Pump PN
1583661-1, or Electric Hydraulic Pumps; PN 1804700-1 (115 VAC) and PN 1804700-2 (220 VAC).
Warning
: To avoid personal injury and potential damage to the crimp head, TE Connectivity (TE) requires the
crimp head to operate at 9,800 to 10,200 PSI [676 to 703 bar]. TE recommends using 10,000 PSI [689 bar] TE
Hydraulic Pumps as other manufacturers’ pumps may apply insufficient pressure (resulting in an inadequate
crimp) or excessive pressure (resulting in failure of the head). Additionally, the TE pump must be used to
maintain CE certification; if
using other manufacturers’ pumps
, the user is responsible for self-certification.
Read these instructions, and all applicable references before inserting any die set assemblies and crimping any
terminals or splices.
NOTE
Dimensions in this instruction sheet are in millimeters [with inches in brackets]. Illustrations and figures are for reference only
and are not drawn to scale.
Reasons for reissue of this Instruction Sheet are provided in Section 9; REVISION SUMMARY
Hydraulic Crimping
Head, PN 1752786-1
O
R
IG
IN
A
L
IN
S
TR
U
C
TIONS