© 2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company
All Rights Reserved
*Trademark
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 2
Instruction Sheet
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
LOC B
408-4847
SMA* Hermetically-Sealed
Panel Feedthrough Jack Receptacles
31 OCT 11 Rev B
Figure 1
Jack
Metal Gasket
1. INTRODUCTION
SMA Hermetically-Sealed Panel Feedthrough Jack
Receptacles 1053159-1, 1053181-1, 1053182-1,
1053226-1, 1053227-1, 1053254-1, 1061372-1, and
1089139-1 are designed to be mounted onto a panel
using the following tools:
TOOL
DESCRIPTION
PART NUMBER CROSS-REFERENCE
TE CONNECTIVITY
M/A-COM
Step Reamer
1055284-1
2098-0442-54
.250-36, UNS-2B
Bottoming Tap
†
- -
2098-5618-54
Torque Tool
1055251-1
2098-0248-54
3/8-in. Open Wrench
†
- -
- -
†
Commercially available
NOTE
i
Unless otherwise specified, dimensions in this
instruction sheet are in metric units [with U.S.
customary units in brackets].
Reasons for reissue of this instruction sheet are
provided in Section 5, REVISION SUMMARY.
2. DESCRIPTION
The jack receptacle consists of a jack and metal
gasket. See Figure 1.
3. ASSEMBLY PROCEDURE
DANGER
STOP
Follow safety precautions included with the tools
used for assembly.
1. Refer to Figure 2, and drill a hole in the panel to
the diameter shown. Using the step reamer, ream
the hole to the depth shown. Using the bottoming
tap, tap the thread to the depth shown.
2. While holding the collet of the torque tool, turn the
handle clockwise until it stops. Thread the jack into
the tool until it bottoms inside the tool. Hand-tighten
the jack. Refer to Figure 3.
NOTE
i
The torque tool is preset between 2.60 and 3.05
Nm [23 and 27 in.-lb].
Recommended Panel Cutout
Note: Dimensions are in inches over millimeters.
Figure 2
Detail A
Detail B
Torque Tool
Collet (Ref)
Jack
Turn Handle
Clockwise
Figure 3
3. Install the metal gasket onto the jack. See
Figure 4.
Metal Gasket
Figure 4
