background image

English version

2

FW021 Sweex 3 Port Firewire PCI Express Card

Introduction

•   Do not expose the Sweex Firewire PCI Express Card to extreme temperatures. Do not place the device in direct sun light or 

close to heating elements. 

•   Do not use the Sweex Firewire PCI Express Card in extremely dusty or moist environments.
•   Prevent hard shocks or impacts of the device, as this can cause damage to the internal electronics.

Hardware Installation

1.   Make sure the computer is turned off and that there is no power connected.
2.   Also remove the printer and monitor cable, because these have their own power supply.
3.   Now unscrew the computer casing.
4.   Make sure that you undo yourself of possible static electricity. This can be done by grabbing a (naked) central heating pipe or 

an unpainted water pipe. Pay attention not to use a magnetic screwdriver. Briefly touch the iron frame of the PC casing. Avoid 
direct contact with the contact points of the PCIe slot and contact points on the graphics card.

5.   Locate a free PCIe slot and remove the metal protection plate that is in the computer casing for the intended slot. Consult the 

manual of your computer to find the PCIe slot.

6.   When possible fasten the card with screws so it can not move.
7.   When the card is mounted successfully, check if the other cards are still fitted properly in their expansion slot. It can happen 

that when a new card is added the other cards rise a little with as result that the card, or even the entire computer, may not 
work.

8.   Close the computer casing and reconnect all cables properly.
9.   Turn on the computer.

Installation Windows 2000 and XP

No drivers are needed for Windows 2000, XP and Vista, the Sweex Firewire PCI Card Express will automatically be installed after 
the start up.

Reviews: